package hardcaml

  1. Overview
  2. Docs
Legend:
Library
Module
Module type
Parameter
Class
Class type

Cycle accurate simulator

module Port_list : sig ... end
module Digest : sig ... end
module Config : sig ... end
type ('i, 'o) t

base type of the cycle based simulators

type t_port_list = (Port_list.t, Port_list.t) t
val circuit : (_, _) t -> Circuit.t Base.option

returns the circuit used to compile the simulation.

val cycle : (_, _) t -> Base.unit

advance by 1 clock cycle (check->comb->seq->comb)

val cycle_check : (_, _) t -> Base.unit

check inputs are valid before a simulation cycle

val cycle_before_clock_edge : (_, _) t -> Base.unit

update combinatorial logic before clock edge and relative to new inputs.

val cycle_at_clock_edge : (_, _) t -> Base.unit

update sequential logic - registers and memories.

val cycle_after_clock_edge : (_, _) t -> Base.unit

update combinatorial logic after clock edge

val reset : (_, _) t -> Base.unit

reset simulator

val in_port : (_, _) t -> Base.string -> Bits.t Base.ref

get input port given a name

val out_port : ?clock_edge:Side.t -> (_, _) t -> Base.string -> Bits.t Base.ref

Get output port given a name. If clock_edge is Before the outputs are computed prior to the clock edge - After means the outputs are computed after the clock edge.

val inputs : ('i, _) t -> 'i
val outputs : ?clock_edge:Side.t -> (_, 'o) t -> 'o
val in_ports : (_, _) t -> Port_list.t
val out_ports : ?clock_edge:Side.t -> (_, _) t -> Port_list.t
val internal_ports : (_, _) t -> Port_list.t

get list of internal nodes

val digest : (_, _) t -> Digest.t Base.ref
val lookup_signal : (_, _) t -> Signal.Uid.t -> Bits.t Base.ref
val lookup_reg : (_, _) t -> Signal.Uid.t -> Bits.t Base.ref
module Violated_or_not : sig ... end
val results_of_assertions : (_, _) t -> Violated_or_not.t Base.Map.M(Base.String).t
val create : ?config:Config.t -> Circuit.t -> t_port_list

construct a simulator from a circuit

module Combine_error : sig ... end
val combine : ?port_sets_may_differ:Base.bool -> ?on_error:(Combine_error.t -> Base.unit) -> ('i, 'o) t -> ('i, 'o) t -> ('i, 'o) t

Combine 2 simulators. The inputs are set on the 1st simulator and copied to the 2nd. Outputs are checked and on_error is called if a difference is found. By default, on_error raises.

The simulators should have the same input and output port sets, unless port_sets_may_differ is true, in which case only ports which exist on both simulators are checked.

module With_interface (I : Interface.S) (O : Interface.S) : sig ... end
module Private : sig ... end
OCaml

Innovation. Community. Security.